Forum

Error Message after boot: CONFIG!  

  RSS

hilei
(@hilei)
New Member
Joined: 3 weeks  ago
Posts: 2
23/11/2018 11:44 pm  

Hi,

I tried set up AWTRIX for hours today - with limited success only.  I copied the two config files to the data dirctory and updated the files with my setting and APIs. firmware was uploaded successfully - but instead the message AP to configure the WLAN the display just shows: CONFIG!

I tried to read the code and CONFIG!config! is shown in case of an error but I was not able to figure out what could be wrong.

I downloaded and opened the project files three times and also tried it with unchanged config files in the data directory - without success.

does anybody have an idea how I get it running.

Thx for any feedback!

 

 

This topic was modified 3 weeks  ago by hilei

ReplyQuote
hilei
(@hilei)
New Member
Joined: 3 weeks  ago
Posts: 2
24/11/2018 12:36 am  

I forgot to mention that all software (atom, ide, firmware...) was downloaded and installed today.


ReplyQuote
Share:
  
Working

Please Login or Register